MB QUART NA2-400.2 400w 2-Channel Amplifier Amp For Polaris/ATV/UTV/RZR/CART

$179.99 $87.30 Save 51%
Shipping calculated at checkout.
Product Description

Features:

  • MB QUART NA2 400.2 400w 2-Channel Amplifier Amp For Polaris/ATV/UTV/RZR/CART
  • Marine Grade Protection: Yes - Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
  • Pre-Amp Circuitry: Q-Stasis Pre Amplifier Stage - The highly engineered Q-Stasis pre-amplifier stage reduces incoming noise from source units dramatically improving sound quality
  • Inputs: 1 Pair, RCA Nickel-Plated - High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
  • Operation Mode: Two channel operation - Flexible installation allows this amplifier to run in two channel or bridged mono mode.
  • Crossover / Signal Shaping: Switched FULL / LPF / HPF - Complete control of amplifier signal, essential when using two or more amplifiers
  • Class / Topology: Full Range Class D - Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
  • Output Devices Technology: PWM MOSFET Power Supply - Stable power through the PC board with minimal heat generation
  • Heat Sink: Aluminum - Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
  • Power Supply: Simpatico Coil Design - The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
  • Output Connections: Quick Dissconect Wires, RCA Connections - Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
  • Connections Type: Gold-plated connections - Gold-plated power, ground, speaker and RCA corrosion resistant connections
  • Diagnostics: Three-stage protection circuits - Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
  • Marinized / Waterproof: Yes - Water resistant for durability in any environment

Specifications:

  • Class: Full Range Class D
  • Variable Voltage: 0.2V~9V
  • Signal to Noise Ratio: >90dB
  • Frequency Response: 20Hz-20kHz
  • Crossover Type: Electronic 12dB Per Octave
  • Low Pass Crossover: Switch Low Pass 300 Hz
  • Bass Boost: 0-12dB@45Hz
  • Subsonic Filter: 60Hz
  • Power @ 2-Ohms: 2 x 200W
  • Power @ 4-Ohms: 2 x 100W
  • Total Channels: 2
  • Audio Inputs: RCA
  • Power Terminal 12v/GND: Molex 10 ga
  • Speaker Terminal Wire Gauge: Molex Plug Connector
  • Fusing: 1 x 30 Amps
  • Certifications: Marine & Powersports
  • Dimensions: 3.70 X 5.51 X 1.77 in (9.4 X 14.0 X 4.5 cm)
  • Weight: 2.12 lbs (0.96 kg)
Shipping & Returns

Row content