MB QUART NA2-400.2 400 Watt RMS 2-Ch. Marine Boat ATV Compact Amplifier+Amp Kit

• (1) MB QUART NA2-400.2 400w 2-Channel Amplifier Amp For Polaris/ATV/UTV/RZR/CART
• (1) Rockville RMWK4 4 AWG Gauge Waterproof Marine Amplifier/Amp Install Wire Kit

Authorized MB Quart Dealer!

Features of NA2-400.2:

• MB QUART NA2 400.2 400w 2-Channel Amplifier Amp For Polaris/ATV/UTV/RZR/CART
• Marine Grade Protection: Yes - Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
  
• Pre-Amp Circuitry: Q-Stasis Pre Amplifier Stage - The highly engineered Q-Stasis pre-amplifier stage reduces incoming noise from source units dramatically improving sound quality
  
• Inputs: 1 Pair, RCA Nickel-Plated - High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
  
• Operation Mode: Two channel operation - Flexible installation allows this amplifier to run in two channel or bridged mono mode.
  
• Crossover / Signal Shaping: Switched FULL / LPF / HPF - Complete control of amplifier signal, essential when using two or more amplifiers
  
• Class / Topology: Full Range Class D - Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
  
• Output Devices Technology: PWM MOSFET Power Supply - Stable power through the PC board with minimal heat generation
  
• Heat Sink: Aluminum - Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
  
• Power Supply: Simpatico Coil Design - The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
  
• Output Connections: Quick Dissconect Wires, RCA Connections - Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
  
• Connections Type: Gold-plated connections - Gold-plated power, ground, speaker and RCA corrosion resistant connections
  
• Diagnostics: Three-stage protection circuits - Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
  
• Marinized / Waterproof: Yes - Water resistant for durability in any environment

Specifications:

• Class: Full Range Class D
  
• Variable Voltage: 0.2V~9V
  
• Signal to Noise Ratio: >90dB
  
• Frequency Response: 20Hz-20kHz
  
• Crossover Type: Electronic 12dB Per Octave
  
• Low Pass Crossover: Switch Low Pass 300 Hz
  
• Bass Boost: 0-12dB@45Hz
  
• Subsonic Filter: 60Hz
  
• Power @ 2-Ohms: 2 x 200W
  
• Power @ 4-Ohms: 2 x 100W
  
• Total Channels: 2
  
• Audio Inputs: RCA
  
• Power Terminal 12v/GND: Molex 10 ga
  
• Speaker Terminal Wire Gauge: Molex Plug Connector
  
• Fusing: 1 x 30 Amps
  
• Certifications: Marine & Powersports
  
• Dimensions: 3.70 X 5.51 X 1.77 in (9.4 X 14.0 X 4.5 cm)
  
• Weight: 2.12 lbs (0.96 kg)

Video of RMWK:

Features:

• Rockville RMWK4 4 AWG Gauge Waterproof Marine/Boat Amplifier Wire Installation Kit
• 20 ’ Translucent, Twisted Pair, High Quality, Tinned-OFC Flexible PVC RCA Cable
• 18’ 4 Gauge High Current, Low Impedance, Clear Flexible Power Cable with 3’ Black Poly Woven Mesh to better resist chemicals in the battery compartment
• 18’ 4 Gauge High Current, Low Impedance, Light Blue, Flexible Ground Cable
• 25’ 16 Gauge 100% Tinned-CCA, White, Non-Transparent Resin PVC, Flat Speaker Cable
• 25’ Blue Remote Wire
• (1) Silver Mini-ANL Fuse Holder – Clear Shell and Clear Blue Bottom Bracket with Blue Waterproof Ring
• (1) 120A Mini-ANL Fuse
• (1) 80A Mini-ANL Fuse
• (2) Ring Terminals
• (2) Spade Terminals
• (5) Speaker Cable Terminals
• (1) Washer
• (10) White Cable Ties

Row content